P0CB1
Hybrid/EV Battery Temperature Sensor N Circuit Intermittent/Erratic
P0CB1 points to an unsteady sensor N signal rather than a lasting short or open. GM's 2019 table 19OBDG02 evaluates windows of ten samples, one every 100 ms, by integrating the absolute value of each change; above 10 the window counts as failed, and 4 failed windows within 5 set the code, Type B, two trips. It needs more than 10.2 V supply and an active data link to the battery interface control module. The 2016 table 16OBDG02 already ran this jitter test, there with U179C as a blocking code. Mitsubishi assigns no erratic code to sensor [13]. Because readings can stay inside the valid band, P0CAF and P0CB0 often remain absent. Loose pins, a damaged sensor lead or a cracked board track are likely, and the fault may come and go with temperature or vibration.
Possible causes
- Loose or fretting pin in the sensor N circuit high
- Chafed or partly broken sensor N lead medium
- Cracked track on the monitoring board low
Symptoms
- Intermittent warning lamp
- Sensor N value jumping in live data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CB1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.