P0CAF
Hybrid/EV Battery Temperature Sensor N Circuit Low
P0CAF sets when the signal of sensor N is pulled under its lower voltage limit. A ground fault in the lead or a shorted thermistor causes this, and because the NTC sensor works against a pull-up resistor the controller interprets it as an implausibly hot module. GM's 2017 HPC2 table 17OBDG02 records a failure once the computed temperature tops 160 °C in 8 of 10 readings, classed as Type B, provided the supply is above 10.2 V and code U179C is not active. The 2012 Volt table accepts N up to 87.5 °C, equal to a raw value from 680 upward. On the Outlander PHEV, Mitsubishi calls it a short of sensor [13], judged below 0.12 V for 2 s and fixed by replacing the battery module or cell monitoring unit. Genuine pack overheating is reported as P0A7E.
Possible causes
- Sensor N lead shorted to ground high
- Thermistor N internally shorted medium
- Measuring input of the cell monitoring unit defective low
Symptoms
- Warning lamp and markedly reduced battery power
- Battery cooling running at full effort
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CAF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.