P0CAD
Hybrid/EV Battery Temperature Sensor N Circuit
P0CAD stands for an electrical problem with battery temperature sensor N that the controller cannot assign to a specific failure type. Public manufacturer documentation for this exact code does not exist. GM's 2011 hybrid rationality list places N fourteenth among sixteen sensors, while its tables from 2012 onward cover N only with the specific codes P0CAE to P0CB1. On the plug-in Outlander, Mitsubishi equates N with module sensor [13] and likewise separates only rationality, short and open. CARB section (e)(15.3.1) is the basis for permanent monitoring of such input circuits. A pack controller without this reading has to plan conservatively for that section. Because the sensor lives inside the traction battery, checks are made only after the high-voltage system has been isolated.
Possible causes
- Connector or wire fault between sensor N and the monitoring board high
- Thermistor N defective medium
- Faulty input channel of the cell monitoring board low
Symptoms
- Hybrid or EV system message
- Battery power reduced until repaired
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CAD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.