OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CAB

Hybrid/EV Battery Temperature Sensor M Circuit High

P0CAB is logged when the input of sensor M rises beyond its upper voltage limit. If the thermistor, one of its wires or the plug opens up, the pull-up resistor lifts the input, and the controller reads a temperature far below anything plausible. GM's HPC2 table 18OBDG02 sets it when 8 of 10 readings at 100 ms intervals are colder than −69 °C, as a Type B fault needing over 10.2 V and intact communication. In the 2011 Volt table the limit was −40 °C, a raw count above 4,000, held 1.4 s within 2 s, and a single trip was enough. Mitsubishi treats it as an open circuit of sensor [12] on the Outlander PHEV: above 3.97 V, below about −62 °C, for 2 s. A plug-in may then heat its battery needlessly or start the engine; P0CAA is the low partner.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / AB

Possible causes

  • Open circuit or unplugged connector of sensor M high
  • Thermistor M open internally medium
  • Corroded or spread terminal at the monitoring board low

Symptoms

  • Battery shown as very cold in mild weather
  • Reduced electric power, engine running more on plug-ins

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0CAB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication