P0CAA
Hybrid/EV Battery Temperature Sensor M Circuit Low
P0CAA means the voltage at sensor M has dropped below its valid band. Sensor M is an NTC element supplied via a bias resistor on the board, so a grounded lead or a shorted element drags the voltage down and reads as an extremely hot spot. GM's 2018 HPC2 table 18OBDG02 fails the test once the converted temperature exceeds 160 °C in 8 of 10 readings taken every 100 ms, Type B, with more than 10.2 V supply. The 2011 Volt table set it above 87.5 °C, a raw count below 680, held for 1.4 s within 2 s over two trips. Mitsubishi's Outlander PHEV calls it a short of sensor [12]: below 0.12 V, roughly above 125 °C, for 2 s; the remedy there is a new battery module or cell monitoring unit. A real overheating shows as P0A7E instead.
Possible causes
- Sensor M signal shorted to ground inside the pack high
- Thermistor M internally shorted medium
- Measuring input of the cell monitoring unit defective low
Symptoms
- Warning lamp with strongly reduced battery power
- Battery cooling running without reason
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CAA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.