P0CA9
Hybrid/EV Battery Temperature Sensor M Circuit Range/Performance
P0CA9 reports that sensor M stays within its electrical limits yet disagrees with what the remaining pack sensors measure. GM's 2012 Volt table 12OBDG01A only runs the comparison once drive system, plug-in charging and battery conditioning have rested for over 21,600 s; a spread above 25.3 °C from the mean in 50 of 67 samples is a Type B failure. The 2018 HPC2 table 18OBDG02 uses 25.00 °C at 25 ms sampling and is suspended whenever circuit faults of the sensors or a communication loss with the battery interface module exist. Mitsubishi uses P0CA9 for module sensor [12] of the Outlander PHEV: after more than 3,600 s soak and at pack temperatures from −30 to 60 °C, a deviation of 13 °C or more from the mean of all 50 sensors for 0.32 s sets it. Drift or a loose sensor is typical.
Possible causes
- Thermistor M drifting while staying in its electrical range high
- Sensor M lost thermal contact with its module medium
- Module section genuinely warmer or colder, e.g. cooling fault or weak cell low
Symptoms
- Warning lamp appearing after a long parking period
- Battery power limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CA9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.