P0CA8
Hybrid/EV Battery Temperature Sensor M Circuit
P0CA8 is the general circuit code for battery temperature sensor M, meant for electrical faults that the controller does not sort into low, high or erratic. No manufacturer publishes this exact code. In GM's 2011 Volt table the rationality list gives M the thirteenth of sixteen positions, yet GM only defines P0CA9 to P0CAC for it. Mitsubishi's Outlander PHEV assigns M to module sensor [12] and also uses only the rationality, short and open codes. CARB section (e)(15.3.1) requires continuous checks of range and continuity for inputs of this kind. Without a usable value the battery controller must assume a hot module section and restricts power. Repair means opening the made-safe traction battery and checking the sensor, its leads and the plug at the monitoring board.
Possible causes
- Poor contact at the plug of sensor M on the monitoring board high
- Thermistor M damaged medium
- Faulty input channel of the cell monitoring board low
Symptoms
- Hybrid or EV warning, possibly with check-engine lamp
- Electric power reduced until repaired
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CA8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.