P0CA6
Hybrid/EV Battery Charging Current High
P0CA6 flags a current into the traction battery that exceeds what the control system expects. Mitsubishi's Outlander PHEV (2018 and 2022) stores it in the PHEV-ECU when, in charging mode, the measured battery current stays above the calculated charger output request for 5 s; suspects are the BMU, the onboard charger/DC-DC converter and the PHEV-ECU, and the repair is confirmed with drive cycle pattern 7. Stellantis sees the code in the battery pack control module (BPCM): a 2023 STAR case for the Wrangler 4xe points to BPCM software, and bulletin 08-025-25 for the 2025 Dodge Charger EV brings charging-related changes against false P0CA6 entries, there combined with P167B and no Drive Ready. P0CA7 is the discharging counterpart.
Possible causes
- Battery control module software (Stellantis S2308000117, 08-025-25) high
- Onboard charger or DC-DC converter delivering more current than requested medium
- Pack current sensor or battery management unit reading wrongly medium
- Fault in the hybrid/PHEV control unit low
Symptoms
- Check-engine lamp, often found after charging
- Charging interrupted or not possible
- Vehicle not entering ready mode on some EVs
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CA6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.