P0CA5
Hybrid/EV Battery Discharging Voltage High
P0CA5 concerns a battery voltage judged too high while the pack is discharging, that is while it supplies the drive motor or other high-voltage consumers. Under load the terminal voltage normally sags, so an excessive value in this state points more to a measurement or plausibility fault than to genuine overcharge. No manufacturer documents P0CA5 publicly. CARB section (e)(15.2.3)(A) demands monitoring of the energy storage system, explicitly including the battery voltage sensors used as its inputs. The charging counterpart P0CA4 shows up in an Audi e-tron charger bulletin as a software ghost entry, so a software check is worthwhile here as well. Useful related checks are the pack voltage code P0AFB and the cell voltage code P0DE7. The battery controller will usually limit power until the cause is found.
Possible causes
- Faulty pack voltage sensing in the battery management high
- Battery or hybrid control software evaluating the voltage wrongly medium
- Loose or corroded high-voltage or sense connection low
Symptoms
- Hybrid or EV warning, often with check-engine lamp
- Limited battery power output
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CA5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.