P0CA3
DC/DC Converter Step Up Voltage Performance
P0CA3 says the boost stage of a DC/DC converter fails to lift its output to the voltage the controller has requested. In full hybrids this stage, often called a boost or variable voltage converter, raises the traction battery voltage to a higher bus level that feeds the inverters. No manufacturer documents P0CA3 on a publicly reachable official server. A Ford patent, US20140252849A1, describes the typical check: a converter voltage is commanded, the gap to the measured value is watched over a calibratable period, and a lasting gap above a threshold produces a diagnostic signal. CARB section (e)(15.2.3) obliges manufacturers to monitor such hybrid components. P0CA2 is the step-down partner, P0A94 the broader converter performance code. Drivers usually notice reduced electric power and a hybrid warning.
Possible causes
- Failed power transistor or driver in the boost stage high
- Internal fault of the inverter/converter assembly, e.g. reactor or capacitor medium
- Wrong reading from the voltage sensor before or after the boost stage medium
- Stored as a consequence of another hybrid system fault low
Symptoms
- Hybrid system warning with check-engine lamp
- Noticeably reduced electric drive power or limp mode
- Engine running more often than usual
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CA3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.