P0C9F
14 Volt Power Module Current Sensor B Circuit High
P0C9F reports an output current from sensor B of the 14 V power module that exceeds what the converter can plausibly supply. GM's 2013 eAssist table 13OBDG05C sets it once the APM output current reading tops 123 A while calculated APM input power is between 0.25 and 1.8 kW, supply voltage is 9 to 32 V and the vehicle is in run/crank; 1.5 s out of a 2 s window fail it, Type B, two trips. Pairing a very high current with modest input power separates a sensor fault from a genuine heavy load. A signal shorted to voltage or an internal sensor defect is typical. P0C9E is the low counterpart, P0A89 the input sensor's high code, and P0CC5 compares both sensors.
Possible causes
- Internal defect of output current sensor B high
- Sensor signal shorted to a voltage source medium
- Poor ground of the power module shifting the reading low
Symptoms
- Check-engine lamp
- Converter output reduced, 12 V battery discharging
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C9F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.