OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C9E

14 Volt Power Module Current Sensor B Circuit Low

P0C9E is set when current sensor B of the 14 V power module reads too little. GM documents it for the eAssist accessory power module in its 2013 table 13OBDG05C: the APM output current measured by the sensor must stay below 2 A for 1.5 s, counted as 60 of 80 samples at 25 ms, with the vehicle in run/crank; the code is Type B, so the MIL comes on after the second failing trip. Since an operating converter feeds considerably more current to the 12 V side, such a reading points to an open signal path, a grounded signal line or a dead sensor. The input-side counterpart is P0A88, the high fault P0C9F. Without valid current data the system may restrict the converter, and the 12 V battery can run down.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 9E

Possible causes

  • Output current sensor B failed inside the module high
  • Sensor signal open or shorted to ground medium
  • Converter not delivering output although enabled low

Symptoms

  • Check-engine lamp after two drives
  • Low 12 V voltage, flickering lights or warning messages

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C9E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication