P0C9C
14 Volt Power Module Current Sensor B Circuit
P0C9C flags an electrical problem, not further classified, with current sensor B of the 14 volt power module, the DC/DC converter that supplies the 12 V network from the high-voltage battery; GM calls it the accessory power module (APM). In GM's 2013 eAssist table sensor B is the APM output current sensor, while sensor A (P0A86 to P0A8A) measures the input side. No manufacturer documents P0C9C publicly; GM uses only the low and high codes P0C9E and P0C9F plus the A/B correlation code P0CC5. CARB rule (e)(15.3.1) calls for continuous range and continuity monitoring of such inputs. With no trustworthy output current the converter may be derated, and the 12 V battery can slowly discharge. The sensor normally sits inside the module.
Possible causes
- Current sensor B inside the power module failed high
- Poor contact at the power module signal connector medium
- Control software of the power module or hybrid controller low
Symptoms
- Warning lamp, sometimes a charging-system message
- 12 V battery running low over time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C9C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.