P0C9A
Hybrid/EV Battery Temperature Sensor L Circuit High
P0C9A is the high-voltage fault of sensor L: an open thermistor, a broken lead or a disconnected plug lets the bias resistor raise the input, and the reading looks like deep frost. GM's 2016 table 16OBDG02 sets it when 8 readings out of 10, taken every 100 ms, are colder than −69 °C; it is Type B and requires more than 10.2 V supply plus working communication. The 2012 Volt table treats readings below −40 °C, a raw count above 4,000, as failed. Mitsubishi assigns no code to sensor L. The controller then plans for a frozen battery, so electric power can be reduced and a plug-in may run its battery heater or engine. Check the plug at the monitoring board first; P0C99 is the short-circuit partner.
Possible causes
- Open circuit or unplugged connector at sensor L high
- Thermistor L open internally medium
- Corroded terminal with very high contact resistance low
Symptoms
- Battery-too-cold indication in mild conditions
- Electric power reduced, engine running more on plug-ins
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C9A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.