P0C99
Hybrid/EV Battery Temperature Sensor L Circuit Low
P0C99 reports a sensor L voltage below the valid range. Because the thermistor works against a bias resistor on its monitoring board, any ground fault or an internally shorted sensor drags the voltage down, which reads as a very hot module. GM's 2019 HPC2 table 19OBDG02 flags it once the converted value exceeds 160 °C in 8 out of 10 readings at 100 ms intervals; it is a Type B code and needs supply above 10.2 V. The 2012 Volt table groups L with the other sensors and passes them only at or below 87.5 °C, which equals a raw count of 680 or more, and needs 1.4 s out of 2 s to fail. Mitsubishi does not use L codes. If the pack is really overheating, P0A7E appears instead. Expect a warning lamp and reduced battery power.
Possible causes
- Sensor L signal shorted to ground high
- Thermistor L shorted internally medium
- Monitoring board channel pulling the input low low
Symptoms
- Warning lamp and reduced battery power
- Battery cooling running for no apparent reason
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C99
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.