P0C98
Hybrid/EV Battery Temperature Sensor L Circuit Range/Performance
P0C98 is the plausibility code for sensor L: its reading is electrically valid but strays too far from the other sensors. GM's table for the 2012 Volt (12OBDG01A) runs the comparison only after more than 21,600 s with propulsion, off-board charging and thermal conditioning all off; a deviation over 25.3 °C, seen in 50 of 67 samples, counts as a Type B failure. In 19OBDG02 from 2019 the limit becomes 25.00 °C with sampling every 25 ms and the same count, and the test pauses while circuit codes for the battery sensors or a lost link to the battery controller are present. Mitsubishi does not use this code. Sensor drift or a detached sensor are the common reasons; P0C99 and P0C9A cover electrical failures.
Possible causes
- Thermistor L drifted within its electrical range high
- Sensor L no longer in thermal contact with its cells medium
- Genuine local temperature difference in that pack section low
Symptoms
- Warning lamp after a long standstill
- Reduced battery power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C98
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.