P0C97
Hybrid/EV Battery Temperature Sensor L Circuit
P0C97 is the catch-all for battery temperature sensor L, used when the input misbehaves electrically but fits none of the low, high or erratic categories. No manufacturer publishes this exact code. GM's 2011 hybrid table counts L as temperature sensor 12 of sixteen, and its 2012 and later tables cover L only with P0C98 to P0C9B. Mitsubishi's Outlander PHEV DTC list goes from sensor [10] (P0C93 to P0C95) straight to sensor [12] (P0CA9 onward), so it uses no L codes at all. CARB paragraph (e)(15.3.1) demands constant supervision of plausibility and circuit integrity for inputs like this. A pack controller that loses sensor L assumes a worst-case temperature for that section and reduces available power until the fault is repaired.
Possible causes
- Connector fault between sensor L and the monitoring board high
- Thermistor L defective medium
- Faulty measuring channel on the monitoring board low
Symptoms
- Hybrid or EV warning, possibly with check-engine lamp
- Limited battery power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C97
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.