P0C96
Hybrid/EV Battery Temperature Sensor K Circuit Intermittent/Erratic
P0C96 flags an unsteady sensor K signal, the kind of noise a loose contact produces while the value still sits inside its valid band. GM describes the monitor in 16OBDG02 and 18OBDG02: each 100 ms sample adds to a running total of absolute changes across 10 samples, a total above 10 marks the window as failed, and 4 failed windows in 5 store the code, Type B, so two bad trips are needed. Supply over 10.2 V and intact communication with the battery interface module are prerequisites. Mitsubishi defines no erratic code for its sensor [10]. Moving the harness by hand while a scan tool shows the value often reveals the cause. P0C94 and P0C95 cover faults where the signal stays out of range.
Possible causes
- Loose contact in the sensor K connector high
- Partly chafed sensor lead touching intermittently medium
- Monitoring board with unstable supply or ground low
Symptoms
- Intermittent warning lamp
- Short spells of reduced power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C96
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.