OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C95

Hybrid/EV Battery Temperature Sensor K Circuit High

P0C95 is set when sensor K delivers a voltage above its valid range. In the usual NTC layout a broken circuit allows the bias resistor to drive the input high, so the controller sees an impossibly cold module. In 19OBDG02 (GM, 2019) a reading colder than −69 °C in 8 out of 10 checks counts as failed, Type B; the 2012 Volt table accepts readings only down to −40 °C, equal to an ADC count of 4,000. Mitsubishi names it an open of sensor [10] on the 2018 Outlander PHEV, above 3.97 V for 2 s. Look for a pushed-out terminal, a broken wire or an unplugged connector before replacing parts. Drivers may see reduced electric power or a warning that the battery is too cold. P0C94 is the matching short-circuit code.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 95

Possible causes

  • Open circuit or disconnected plug at sensor K high
  • Thermistor K open internally medium
  • Sensor lead damaged during earlier work on the pack low

Symptoms

  • Battery-too-cold or plug-in-to-warm message in mild weather
  • Electric power reduced or unavailable

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C95

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication