P0C94
Hybrid/EV Battery Temperature Sensor K Circuit Low
With P0C94 the controller sees the sensor K signal pulled below its lower limit, a pattern produced by a chafed wire touching ground or an internally shorted thermistor, which the conversion turns into an extreme temperature. GM's 2016 table 16OBDG02 counts a failure whenever the converted value is hotter than 160 °C and needs 8 such readings out of 10, one every 100 ms, Type B; in the 2012 Volt table the same sensor group passes only at or below 87.5 °C. The 2018 Outlander PHEV from Mitsubishi files a short of sensor [10] when the voltage stays below 0.12 V for 2 s. Unlike with the over-temperature code P0A7E, the pack itself is usually not hot. The battery controller nonetheless limits power and may keep the cooling busy; the open-circuit partner is P0C95.
Possible causes
- Sensor K signal line shorted to ground high
- Thermistor K shorted internally medium
- Moisture or coolant reaching the sensor K connection low
Symptoms
- Warning lamp and reduced electric power
- Battery cooling running although the pack is not hot
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C94
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.