P0C90
Hybrid/EV Battery Temperature Sensor J Circuit High
P0C90 reports the opposite case: sensor J reads above its voltage window, which with a pull-up circuit points to an open thermistor, a broken lead or a disconnected plug, and the controller sees an impossibly cold module. In GM's 2016 and 2019 tables (16OBDG02, 19OBDG02) a converted value colder than −69 °C in 8 out of 10 readings, one every 100 ms, fails the test; it is Type B, so the lamp waits for the second bad trip, and it runs only above 10.2 V with communication intact. For sensor [09] of the 2018 Outlander PHEV, Mitsubishi records an open when more than 3.97 V, below −62 °C, persists for 2 s. Because the battery seems frozen, the system may limit power, keep the engine running or ask for warming on a plug-in. P0C8F is the short-circuit counterpart.
Possible causes
- Open lead or unplugged connector at sensor J high
- Thermistor J open internally medium
- Terminal pushed back in the monitoring board plug low
Symptoms
- Battery-too-cold message although the weather is mild
- Little or no electric drive power
- Battery heater switching on without need
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C90
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.