OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C8F

Hybrid/EV Battery Temperature Sensor J Circuit Low

P0C8F means the voltage on sensor J has dropped below its valid window. The NTC thermistor is powered via a pull-up resistor, so a grounded signal line reads as an absurdly hot cell group; low refers to the signal. GM's HPC2 table of 2019 (19OBDG02) converts the voltage and fails the test if the result is over 160 °C for 8 samples out of 10, sampled every 100 ms and rated Type B. The older 2012 Volt table judges all sensors together and fails them above 87.5 °C (raw count under 680) for 1.4 s of a 2 s window. On the 2018 Outlander PHEV, Mitsubishi logs a short of sensor [09] once the signal remains below 0.12 V, hotter than 125 °C, for 2 s. A genuinely overheating pack would instead set P0A7E. Expect reduced power and battery cooling running hard.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 8F

Possible causes

  • Sensor J signal wire chafed and shorted to ground high
  • Thermistor J shorted internally, for example after moisture medium
  • Monitoring board input pulling the line low low

Symptoms

  • Warning lamp with clearly reduced electric power
  • Battery fan or chiller running constantly
  • Engine starts more often on plug-in hybrids

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C8F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication