P0C8C
Hybrid/EV Battery Temperature Sensor I Circuit Intermittent/Erratic
P0C8C reports that sensor I changes faster and more often than any real battery temperature could. GM is the only maker that publishes the test: in 19OBDG02, the 2019 hybrid powertrain control module 2 table, each 10-sample window at 100 ms per sample is scored by the summed absolute change of the reading, a score above 10 counts as a failed window, and 4 failed windows out of 5 set the code, Type B, two trips, with system voltage above 10.2 V and no communication fault to the battery interface module. The 2018 table 18OBDG02 contains the same rule. Unlike P0C8A and P0C8B the value never leaves its valid range. Look for a fretting terminal or a wire broken inside its insulation; several erratic sensors at once point to the sensing board.
Possible causes
- Fretting or loose terminal on the sensor I connector high
- Sensor I wire broken inside its insulation medium
- Sensing board with unstable supply or ground low
Symptoms
- Warning lamp appearing now and then
- Sensor I value jumping in live data
- Short phases of reduced power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C8C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.