P0C8B
Hybrid/EV Battery Temperature Sensor I Circuit High
P0C8B covers a sensor I signal stuck above its valid voltage, which the controller interprets as extreme cold. An interrupted circuit lets the pull-up lift the line, so the root cause is usually an open connection or a failed thermistor rather than the weather. On the 2016 Cadillac ELR (16OBDG01) GM fails it below −40 °C, an ADC count above 3992, for 1.4 s within 2 s, two trips. Mitsubishi's 2018 Outlander PHEV declares channel [08] open beyond 3.97 V, colder than −62 °C, held 2 s. For the Volt, bulletin 18-NA-342 lists it as sensor 9 circuit high voltage among codes that can come with a Battery Too Cold message above −25 °C and recommends new module software. The short-circuit counterpart is P0C8A.
Possible causes
- Open wire or loose connector in the sensor I circuit high
- Thermistor I open medium
- Battery module software causing false cold readings (GM Volt, 18-NA-342) low
Symptoms
- Battery-too-cold message although outside temperature is mild
- Electric drive limited or unavailable
- Battery heater running unnecessarily
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C8B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.