P0C84
Hybrid/EV Battery Temperature Sensor H Circuit High
P0C84 is set when the sensor H line sits too high in voltage, which the controller converts into an impossible cold reading. The pull-up drives an interrupted circuit upward, so an open wire, a pushed-out pin or a broken thermistor are the classic triggers. In GM's 2012 Volt table (12OBDG01A) the limit is below −40 °C, an ADC count above 4000, held for 1.4 s within a 2 s window; the 2019 table 19OBDG02 uses −69 °C in 8 of 10 samples, Type B. Mitsubishi's Outlander PHEV of 2022 sees an open of sensor [07] above 3.97 V, below −62 °C, for 2 s. A cold-weather complaint with a Battery Too Cold message on the Volt may be software, per bulletin 18-NA-342. The short-to-ground counterpart is P0C83.
Possible causes
- Broken wire or backed-out pin in the sensor H circuit high
- Thermistor H open medium
- False set by battery module software (GM Volt, 18-NA-342) low
Symptoms
- Battery-too-cold message in mild weather
- Electric drive limited or unavailable
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C84
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.