OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C7F

Hybrid/EV Battery Temperature Sensor G Circuit High

With P0C7F the sensor G input reads above its valid voltage range. Because the pull-up raises the line when the thermistor is disconnected, an open circuit, broken wire or unplugged connector shows up as an implausibly cold cell group. GM's 2016 Cadillac ELR table (16OBDG01) sets it below −40 °C for 1.4 s within a 2 s window, two trips, and the 2019 table 19OBDG02 below −69 °C in 8 of 10 samples, Type B. Mitsubishi's Outlander PHEV of 2018 calls it a sensor [06] open once the voltage exceeds 3.97 V, colder than −62 °C, for 2 s. On the Volt, GM bulletin 18-NA-342 links these sensor 7 high-voltage sets to a Battery Too Cold message above −25 °C and cures false ones with new software. Its short-circuit partner is P0C7E.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 7F

Possible causes

  • Open circuit or unplugged connector at sensor G high
  • Thermistor G open internally medium
  • Module software setting it falsely in mild cold (GM Volt, 18-NA-342) low

Symptoms

  • Battery-too-cold or plug-in-to-warm message although it is not very cold
  • Reduced electric power or no electric drive
  • Battery heater switched on without need

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C7F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication