P0C7E
Hybrid/EV Battery Temperature Sensor G Circuit Low
P0C7E means the sensor G voltage has fallen below its valid range. The thermistor has a negative temperature coefficient and a pull-up on the sensing board, so a short to ground looks like an extremely hot cell group; low describes the signal, not the temperature. GM's 2019 table for hybrid powertrain control module 2 (19OBDG02) fails it when the converted reading exceeds 160 °C in 8 of 10 samples taken every 100 ms, Type B, two trips; bulletin 18-NA-342 files it under sensor 7 as a low-voltage fault on the Volt. Mitsubishi's Outlander PHEV of 2022 sets it as a sensor [06] short when the voltage stays under 0.12 V, above 125 °C, for 2 s. The open-circuit opposite is P0C7F; a pack that really runs hot reports P0A7E. Expect power limits and hard-working battery cooling.
Possible causes
- Sensor G signal line chafed through and shorted to ground high
- Thermistor G shorted internally, often after moisture entry medium
- Input stage of the cell monitoring board pulled low low
Symptoms
- Warning lamp with sharply reduced electric power
- Battery cooling fan or chiller running constantly
- Engine runs more often on plug-in hybrids
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C7E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.