P0C7C
Hybrid/EV Battery Temperature Sensor G Circuit
P0C7C is the umbrella circuit code for battery temperature sensor G, used when the controller sees an electrical fault in that input without sorting it into low, high or erratic. No manufacturer documents P0C7C publicly. GM numbers sensor G as sensor 7 of the nine thermistors in the Volt pack (bulletin 18-NA-342), yet its hybrid tables only carry the narrower codes P0C7D to P0C80; Mitsubishi likewise splits sensor G into rationality, short and open. CARB section (e)(15.3.1) asks for continuous checks of range and circuit continuity on every such input. Without a trustworthy reading the battery controller has to assume the worst for that cell group and trims charge and discharge power. The thermistor lives inside the high-voltage pack, so testing needs HV safety procedures.
Possible causes
- Corroded or loose connector between sensor G and the sensing board high
- Thermistor G failed electrically medium
- Faulty input stage on the cell monitoring board or battery module low
Symptoms
- Hybrid or EV system warning lamp, check-engine lamp on many models
- Reduced electric power and slower charging
- Battery cooling or heating running without obvious need
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C7C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.