P0C79
Drive Motor A Inverter Voltage Too High
P0C79 reports that the DC voltage at the inverter of drive motor A rose above its protection limit. Overvoltage can come from regenerative energy the battery cannot absorb, from a contactor opening under load or a loose high-voltage connection, and it can also be a false reading. In the 2018 Outlander PHEV a hardware comparator in the front motor control unit trips at 370 V; one event with the IGBTs active, or 0.5 s with them shut down, sets the code; after ruling out other voltage codes, the manual checks the torque of the battery cable at the power drive unit. Subaru revised its diagnosis for the 2014-2015 Crosstrek Hybrid (16-114-18), and Audi traces intermittent P0C7900 on the Q4 e-tron to software. Drive motor B uses P0C7A, the generator P0C7B.
Possible causes
- Battery cable at the inverter loose or not at specified torque medium
- Inverter or its voltage detection faulty medium
- Voltage spike from regeneration or a contactor opening under load medium
- Motor control software, fixed by an update low
Symptoms
- Hybrid or EV warning lamp, electrical system fault message
- Drive system will not activate or shuts down until restarted
- Reduced drive power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C79
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.