OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C78

Hybrid/EV Battery System Precharge Time Too Long

P0C78 means precharge took too long: the inverter side did not come up to battery voltage within the allowed time. GM's 2011 Volt allows 700 ms to reach 95 % (Type A), the 2013 eAssist 1,000 ms or more than 5 A for over 100 ms (Type B), and the 2019 tables demand 95-105 % at 0.700 s, Type A. The 2018 Outlander PHEV flags a gap of 12 V or more between battery and inverter after 1 s. Typical causes are an open precharge resistor or fuse, a high-voltage load pulling the bus down, and software. Bulletins cover a blown fuse in the service disconnect (Bolt EV, 18-NA-225), a failed coolant heater (Spark EV, 16-NA-072) and battery-module software at Chrysler and Volvo. The vehicle then normally will not become ready.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 78

Possible causes

  • Precharge resistor, precharge contactor or high-voltage fuse open high
  • Faulty high-voltage consumer such as a coolant heater loading the bus medium
  • Battery module software, fixed by an update medium
  • Loose high-voltage cable or bus bar low

Symptoms

  • Vehicle does not become ready to drive
  • Malfunction indicator lamp and drive system message
  • Loss of propulsion

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C78

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication