P0C72
Hybrid/EV Battery Temperature Sensor E/F Correlation
P0C72 is the agreement test between battery temperature sensors E and F. The controller stores it when the two readings stay apart by more than a calibrated margin after the pack has had time to even out. No manufacturer documents P0C72 publicly; GM names the matching single-sensor plausibility codes P0BC3 (sensor 5) and P0C34 (sensor 6) and compares each with the pack average, Type B. On the Chevrolet Volt GM traced false sensor codes, together with a battery-too-cold message above -25 °C, to module software and cured them by reprogramming (18-NA-342), so a software check comes before any pack work. If the fault is real, a drifting thermistor, a sensor that lost contact with its module or uneven coolant flow are typical. Battery power is then limited. The D/E pair is P0C71.
Possible causes
- Battery module software that reports sensor faults falsely, fixed by reprogramming medium
- Thermistor E or F drifted without an electrical fault high
- Sensor detached from its cell group medium
- Uneven coolant or air flow through the pack low
Symptoms
- Hybrid or EV system warning lamp
- Battery-too-cold or similar message although it is not very cold
- Reduced electric power and range
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C72
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.