OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C68

Generator Position Sensor Circuit A Intermittent/Erratic

P0C68 is stored when circuit A of the generator resolver drops out or jumps for short moments and then looks normal again, so neither the low nor the high limit is held long enough to set P0C66 or P0C67. Vibration at a connector, a chafed lead or contacts that loosen with heat are the usual suspects. No manufacturer documents P0C68 publicly. GM gives a practical example for this kind of weakness: on the 2011-12 Volt it replaced the original 2x4 resolver plug of motor A, a part GM lists as the generator position sensor stator, with a sealed 1x6 plug because the signal suffered under vibration, and warns that a misplaced harness lets the phase cables disturb the signal (PIC6136A). Such faults often appear only on rough roads or when hot.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 68

Possible causes

  • Resolver connector with poor contact that opens under vibration high
  • Harness rubbing through intermittently in the transaxle or generator area medium
  • Bursts of interference from nearby phase cables due to harness routing medium
  • Contact or winding joint that fails only at high temperature low

Symptoms

  • Warning lamp that comes and goes
  • Brief jolts or interruptions in generator operation
  • Fault appears mainly on bad roads or after long drives

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C68

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication