OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C62

Drive Motor B Position Sensor Circuit B High

P0C62 means the reference level on the S2/S4 winding circuit of the motor B resolver climbs above its upper limit. GM triggers it at 4.5 V on the 2011 and 2016 Volt and ELR, 4.9 V on the 2019 Volt and 3.0 V on the 2012 two-mode trucks; on the 2016 Volt the level must stay high for 0.2125 s within 0.3125 s, rated Type B over two trips. P0C62 shows up in every GM note of the PIC5856 series, from the 2013 original to version F of 2019, for 2011-13 Volt and 2014-16 ELR, usually paired with P0C58 and sometimes P0C57. Because both windings of the same resolver report high at once, GM's remedy after clean wiring checks is a new motor B position sensor plus the latest module calibration.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 62

Possible causes

  • Faulty motor B position sensor on 2011-13 Volt and 2014-16 ELR (GM PIC5856) high
  • Open S2 or S4 wire or terminal backed out of the connector medium
  • Drive motor generator control module without the latest calibration low

Symptoms

  • Service engine soon lamp, often with P0C58
  • Reduced propulsion power
  • Code may return after clearing until the sensor is replaced

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C62

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication