P0C61
Drive Motor B Position Sensor Circuit B Low
P0C61 reports a reference level below the lower limit on the S2/S4 winding circuit of the motor B resolver. GM uses 0.5 V on the 2011 and 2016 Volt and the 2012 two-mode trucks, 0.10 V on the 2019 Volt, and needs the low reading for 50 of 80 samples on early cars, 0.25 s within 0.375 s on the 2019 model. A documented field case comes from the 2008 Tahoe and Yukon Hybrid: GM's PIP4607A describes no-crank or intermittent start complaints with P0A45, P0C61, P0A46 and P1B04, traced to a badly crimped pin 20 in the 24-way transmission pass-through connector X176; vehicles built before VIN 8R217000 receive a new internal transmission harness. P0C62 is the high side.
Possible causes
- Poor crimp at the transmission pass-through connector (GM PIP4607A, 2008 Tahoe/Yukon Hybrid) high
- S2/S4 line of motor B shorted to ground medium
- Shorted S2/S4 winding in the motor B resolver low
Symptoms
- Engine does not crank or cranks only intermittently
- Check engine lamp with several resolver codes of motor B
- Reduced propulsion
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C61
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.