OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C60

Drive Motor B Position Sensor Circuit B Range/Performance

P0C60 indicates that the second winding of the motor B resolver (Circuit B) is electrically intact but delivers values the controller rejects as unrealistic, for example an amplitude that no longer agrees with the first winding or an angle that jumps against the measured speed. No manufacturer documents this code publicly. The idea behind it is the separate rationality test that CARB demands for input sensors, apart from circuit and range checks. Practical suspects are contact resistance at the plug, a resolver stator that has moved or been damaged, and stray coupling from the high-voltage phase cables onto a poorly shielded line. P0C61 to P0C63 cover low, high and sporadic Circuit B faults, P0A46 the combined signal.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 60

Possible causes

  • Raised contact resistance at the motor B resolver connector high
  • Motor B resolver stator shifted or damaged medium
  • Interference from the high-voltage phase cables through a damaged shield low

Symptoms

  • Hybrid system warning with check engine lamp
  • Motor B output limited
  • Vibration or noise when motor B is under load

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C60

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication