OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C5F

Drive Motor B Position Sensor Circuit B

P0C5F is the umbrella circuit code for Circuit B of the motor B resolver, which GM wires as the S2/S4 winding of the second traction motor. It fits a fault on that winding that the controller notices but cannot assign to a low or high reading. No manufacturer documents this code publicly; on GM's dual-motor hybrids the same winding is covered by P0C61 and P0C62 only. Together, P0C55 and P0C5F let a technician see whether one or both windings of motor B are affected: one alone points to that winding's wires, both together to the shared plug, the excitation or the motor control module. P0A45 reports the overall motor B angle signal. Expect a warning lamp and the loss of motor B.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 5F

Possible causes

  • Open wire or loose terminal in the motor B S2/S4 lines high
  • Damaged motor B resolver or pass-through connector medium
  • Defective second pickup winding in the motor B resolver medium

Symptoms

  • Hybrid warning and check engine lamp
  • Motor B shut off, lower propulsion
  • Possible no-start on hybrids that crank with motor B

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C5F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication