OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C5A

Drive Motor A Position Sensor Circuit B

P0C5A is the base circuit code for Circuit B, the second pickup winding of the motor A resolver; GM calls it the S2/S4 winding, set 90 degrees from the S1/S3 winding of Circuit A. The code is meant for a fault on that winding which the controller cannot class as a low or high level. No manufacturer documents this code publicly. GM checks the S2/S4 line only through P0C5C and P0C5D. If P0C5A appears on its own, the problem is limited to the second winding and its two wires; if P0C50 is stored too, a shared part such as the connector or the excitation side is more likely. P0A3F, by contrast, covers a lost angle signal without naming a winding. Expect a warning and possibly no electric drive.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 5A

Possible causes

  • Open wire or loose terminal in the S2/S4 (Circuit B) lines high
  • Damaged or corroded resolver connector medium
  • Defective second pickup winding in the resolver stator medium

Symptoms

  • Check engine lamp with drive system warning
  • Electric drive limited or unavailable
  • Vehicle may refuse to enter ready mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C5A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication