OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C59

Drive Motor B Position Sensor Circuit A Intermittent/Erratic

P0C59 reports that Circuit A of the motor B resolver drops out or jumps for moments only, without a fault that persists as low, high or implausible. No manufacturer documents this code publicly. Where a dual-motor system uses it, the cause is nearly always mechanical: a terminal that loses grip under vibration, a cable section that flexes with the transmission, or water creeping into a plug. The GM truck note PIP4607A shows how a single poorly crimped terminal at the transmission pass-through connector can upset resolver signals of motor B. Since short glitches on a position signal disturb torque control, the controller may still cut motor B briefly. P0C57 and P0C58 are the steady faults on the same winding.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 59

Possible causes

  • Poorly crimped or loose terminal in the motor B Circuit A path high
  • Wire breaking inside its insulation where the harness flexes medium
  • Water ingress at the resolver or pass-through connector medium

Symptoms

  • Warning lamp that comes and goes
  • Short loss of motor B assistance or a jerk
  • Intermittent start problems on some hybrids

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C59

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication