P0C55
Drive Motor B Position Sensor Circuit A
P0C55 is the general circuit code for the first pickup winding (Circuit A) of the resolver on the second traction motor. It applies when the motor B controller recognises a fault on that winding but cannot assign it to a low or high level. No manufacturer documents this code publicly. GM, which runs two motors in the Volt, ELR and the two-mode trucks, files motor B winding faults under P0C57 and P0C58 instead. Compared with P0A45, which reports the motor B angle signal as a whole, P0C55 narrows the search to one winding and its two wires. CARB requires such circuit faults to be detected separately from out-of-range faults. The result is usually a warning lamp and the loss of motor B for drive or charging.
Possible causes
- Open wire or loose terminal in the motor B Circuit A lines high
- Damaged or corroded motor B resolver connector medium
- Defective first pickup winding in the motor B resolver medium
Symptoms
- Check engine lamp with hybrid system warning
- Motor B unavailable, reduced propulsion
- Engine may run more often because the second motor is offline
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0C55
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.