P0C53
Drive Motor A Position Sensor Circuit A High
P0C53 is the high counterpart of P0C52: the reference level on the S1/S3 winding circuit of the motor A resolver rises above its window, typical of a short to a voltage source or an open line that floats up. GM uses an upper limit of 4.5 V on the 2011 Volt, 2013 eAssist and 2016 Volt and ELR, 4.9 V on the 2019 Volt and only 3.0 V on the 2012 two-mode Tahoe, Yukon, Escalade, Sierra and Silverado hybrids. It reacts faster than on the low side: 20 of 30 samples (about 208 ms) on the 2011 Volt, 0.2125 s within 0.3125 s on the 2016 Volt. MIL logic is Type A on the 2011 Volt and the 2012 trucks, Type B on eAssist and the later Volt. No bulletin names this code for motor A.
Possible causes
- Open S1 or S3 line or a terminal that has backed out, letting the input drift high high
- Circuit A line shorted to a voltage-carrying wire in the harness medium
- Broken S1/S3 winding in the resolver stator medium
- Faulty resolver input in the motor control module low
Symptoms
- Check engine lamp with hybrid system message
- Reduced propulsion or electric drive unavailable
- Rough engine running on vehicles that use motor A for starting
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0C53
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.