OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C52

Drive Motor A Position Sensor Circuit A Low

P0C52 reports that the DC reference level on Circuit A of the motor A resolver, the S1/S3 winding in GM terms, has dropped too low, which points to a short to ground or a line pulled down. GM fails it below 0.5 V on the 2011 Volt, 2012 two-mode trucks, 2013 eAssist and 2016 ELR, and below 0.10 V on the 2019 Volt. Timing ranges from 50 of 80 samples taken every 10.4 ms (one trip, Type A) to 0.525 s within 0.8375 s on the 2016 Volt or 0.25 s within 0.375 s on the 2019 Volt (both Type B). Bentley finds P0C5200, often with P0C5C00, on 2020-22 Bentayga Hybrids with a chafed 12 V transmission harness. Unlike P0A41, which rates the whole signal, this code names one winding.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 52

Possible causes

  • Chafed or pinched transmission harness shorting a Circuit A line to ground (Bentley TPI 2066714) high
  • Water or corrosion in the resolver connector medium
  • Shorted S1/S3 winding inside the resolver stator medium
  • Faulty resolver input in the motor control module low

Symptoms

  • Check engine lamp, often with P0C5C stored at the same time
  • Electric drive shut off or power reduced
  • On some hybrids the engine runs constantly or the car will not start

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C52

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication