OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C50

Drive Motor A Position Sensor Circuit A

A resolver has two pickup windings set 90 degrees apart, one giving a sine and one a cosine signal. The codes P0C50 onward judge each of those circuits on its own, while P0A3F to P0A43 judge the combined angle signal. GM names the S1/S3 winding Circuit A and the S2/S4 winding Circuit B. P0C50 is the general entry for Circuit A of motor A, used when the controller sees a fault in that line without classing it as a low or high reading. No manufacturer documents this code publicly; GM covers the same winding only through P0C52 and P0C53. CARB requires circuit faults of such inputs to be detected and stored separately from out-of-range faults. Expect a warning lamp and possibly lost electric drive.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 50

Possible causes

  • Open wire or loose terminal in the Circuit A (first pickup winding) lines high
  • Corroded or damaged connector between resolver and motor control module medium
  • Defective pickup winding inside the resolver stator medium
  • Fault in the resolver input stage of the motor control module low

Symptoms

  • Hybrid or drive system warning together with the check engine lamp
  • Electric drive switched off or reduced power
  • Vehicle may not reach ready mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C50

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication