OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C4C

Hybrid/EV Battery Pack Coolant Pump A Supply Voltage Circuit Low

P0C4C reports that the supply voltage reaching battery coolant pump A is below the expected level while the circuit is not fully open. Typical reasons are high resistance in the feed, a corroded fuse contact, a weak relay, a poor ground or a short to ground that drags the line down. No manufacturer documents P0C4C publicly. Ford uses the sibling P0C4B for the open supply circuit on its 2020 Escape, Explorer and Aviator hybrids, and Bentley's bulletin on P0C4700 for 2025–2026 Continental GT and Flying Spur hybrids shows what such a feed contains: a 10 A fuse, a relay and a harness route that can chafe at the rear suspension. CARB requires the electrical parts of battery thermal management to be monitored. A pump that receives too little voltage runs slowly or not at all.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 4C

Possible causes

  • High resistance from corroded fuse, relay contacts or connector high
  • Poor pump ground connection medium
  • Supply wire chafed and shorted to ground low

Symptoms

  • MIL or hybrid or EV warning
  • Coolant pump running slowly or intermittently
  • Battery power reduced when the pack warms up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0C4C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication