OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C45

Hybrid/EV Battery Pack Coolant Temperature Sensor A Circuit High

P0C45 indicates that the signal of battery coolant temperature sensor A sits near the reference voltage. On an NTC circuit with pull-up this looks like extreme cold and usually comes from an open circuit, an unplugged connector or a short to voltage. GM uses the code in the battery energy control module: the 2011 Chevrolet Volt fails the test below -40 °C at an ADC count above 3823, the 2019 hybrid tables at a count above 3890. In both cases 1.75 s within 2.5 s are needed, and the Type B rating lights the MIL after two trips. With the inlet reading lost, the controller runs the battery cooling and heating on substitute values and may cut power in hot or cold weather. The low counterpart is P0C44; sensor B reports the same fault as P0CD8.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 45

Possible causes

  • Open signal or ground wire, or connector not latched high
  • Coolant temperature sensor open internally medium
  • Signal wire shorted to a voltage source low

Symptoms

  • MIL after two trips
  • Coolant temperature shown at about -40 °C in live data
  • Reduced charging power in extreme temperatures

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C45

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication