P0C44
Hybrid/EV Battery Pack Coolant Temperature Sensor A Circuit Low
P0C44 reports that the voltage of battery coolant temperature sensor A is too low. The sensor is an NTC thermistor, so a low voltage translates into a very hot reading, and a short to ground or a shorted element is the classic cause. GM documents the code in the battery energy control module: the 2011 Chevrolet Volt sets it when the inlet coolant value reaches 87.9 °C (ADC count 130 or less), the 2019 hybrid tables use the same temperature at an ADC count of 133 or less. The fault must be present for 1.75 s within a 2.5 s window; as a Type B code it turns on the MIL after the second trip. Because the controller can no longer trust the coolant value, it may limit battery power. P0C45 is the high counterpart, P0C42 the generic circuit code.
Possible causes
- Sensor signal wire chafed through and shorted to ground high
- Internally shorted coolant temperature sensor medium
- Coolant or water in the connector bridging the pins low
Symptoms
- MIL and hybrid or EV system message
- Coolant temperature shown implausibly high in live data
- Limited charging or drive power
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0C44
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.