OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C43

Hybrid/EV Battery Pack Coolant Temperature Sensor A Circuit Range/Performance

P0C43 flags battery coolant temperature sensor A as electrically valid but not believable. GM's 2019 hybrid tables describe a cold-soak comparison: once all high-voltage contactors and the battery heater have been off for at least 14,400 s, the hybrid controller compares inlet coolant temperature with the average cell temperature and with outside air, failing when the gaps reach about 23 °C and 22 °C; 8 s out of 10 s set a Type B code, so the MIL follows on the second trip. Audi uses P0C4300 in the thermal management module of the 2020 Q5 TFSI e. Bulletin 2059530 and update 80C9 explain that the stored limits were set too tightly for everyday conditions, so the code and P0CE100 appeared without a defect; new software fixes it. CARB demands rationality checks for battery thermal inputs.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 43

Possible causes

  • Too tight plausibility limits in the control software (Audi Q5 TFSI e, update 80C9) high
  • Coolant sensor A drifting away from its characteristic medium
  • Added resistance in the sensor circuit shifting the reading low

Symptoms

  • MIL after a cold start, often with no other complaint
  • Battery thermal management working on substitute values

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C43

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication