OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C3F

DC/DC Converter Temperature Sensor B Low

P0C3F is stored when the voltage from the second temperature sensor of the DC/DC converter falls below the lowest plausible value. These sensors are normally NTC thermistors fed through a pull-up resistor, so a low voltage corresponds to an extremely hot reading; a short to ground or a shorted element produces exactly that. No manufacturer documents P0C3F publicly. GM uses the same logic for comparable hybrid thermistors, flagging a low circuit once the computed temperature reaches about 88 °C. Mercedes-Benz lists the opposite fault of the same sensor, P0C40, on the EQB and G-Class. CARB requires hybrid component inputs to be checked for out-of-range signals. The converter usually derates to protect itself, so 12 V charging suffers. Sensor A's low code is P0C3A.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 3F

Possible causes

  • Sensor B signal line shorted to ground in the converter or harness high
  • Shorted thermistor B, usually only fixable by replacing the converter medium
  • Converter actually overheating because its cooling fails low

Symptoms

  • Hybrid or EV system warning in the cluster
  • 12 V battery warning or falling on-board voltage
  • Reduced power or switched-off comfort consumers

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C3F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication