OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C3B

DC/DC Converter Temperature Sensor A High

P0C3B reports a signal from DC/DC converter temperature sensor A above its valid range, typically a short to positive or an open circuit pulled up by the input. Mercedes-Benz documents it on series 243 (EQB) and 465 (G-Class, including the electric G 580): information LI54.10-P-079533 describes P0C3B00 as a short circuit to positive of temperature sensor A, stored together with P0E9700, P0E5400 and P0C4000 after faulty wake-up behaviour of the converter. Drivers see a red 12 V battery message and white or yellow HV warnings. The remedy is a converter check in XENTRY, clearing the fault memory and a converter reset; parts are not replaced first. The low-signal sibling is P0C3A, sensor B's high code is P0C40.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 3B

Possible causes

  • Faulty wake-up behaviour of the converter putting it into an error state (Mercedes 243/465) high
  • Open circuit or short to positive in the sensor A circuit medium
  • Internal defect of the DC/DC converter low

Symptoms

  • Red 12 V battery warning in the cluster
  • White or yellow high-voltage system warning
  • 12 V battery no longer charged while driving

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C3B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication