P0C3A
DC/DC Converter Temperature Sensor A Low
P0C3A means the signal of DC/DC converter temperature sensor A is below its valid range. Low refers to the signal voltage: with an NTC thermistor and pull-up, as GM uses for its hybrid temperature sensors, a short to ground or a failed element reads as extreme heat. No manufacturer documents P0C3A publicly. Mercedes-Benz shows the opposite case for the same sensor, P0C3B as a short to positive, on the EQB and the G-Class, and Ram the plausibility code P0C39. CARB requires the converter's inputs to be checked for out-of-range values. Because the controller must assume an overheated power stage, it limits or stops the converter output; the 12 V battery then supplies the car alone and a low-voltage warning may follow. The sensor is usually built into the converter.
Possible causes
- Sensor A signal shorted to ground inside the converter or its harness high
- Shorted temperature element A, usually requiring converter replacement medium
- Converter really overheated due to a cooling fault low
Symptoms
- Hybrid or EV system warning
- 12 V battery warning, system voltage dropping
- Reduced power or restricted functions
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C3A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.