OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C37

Hybrid/EV Battery Temperature Sensor F Circuit Intermittent/Erratic

P0C37 targets a sensor F signal that jumps instead of following the slow temperature change of a heavy battery. GM documents the logic in its 2016 to 2018 hybrid tables (16OBDG02, 17OBDG02, 18OBDG02): every 100 ms the controller adds up the absolute changes of the sensor value over a window of 10 samples; a sum above 10 fails the window, and 4 failed windows out of 5 set the code as Type B, two trips, with system voltage above 10.2 V and no communication fault active. The Volt, Two-Mode and eAssist tables have no erratic code for this sensor. Unlike P0C35 and P0C36, the signal stays inside its valid range, so the cause is usually a loose terminal or a cracked wire. If several sensors jump at once, the sensing board is the likelier suspect.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 37

Possible causes

  • Loose terminal or connector of sensor F not fully latched after pack work high
  • Cracked sensor wire with intermittent contact medium
  • Faulty battery sensing board, often with several sensors affected low

Symptoms

  • MIL after two trips
  • Intermittent hybrid warning, often on rough roads
  • Temporarily reduced power

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0C37

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication